25-9-84
Section 25-9-84 Coursing of air. (a) Two available openings to the surface are required from each seam or stratum of coal worked. In drift or slope mines, such openings provided after August 12, 1949, must be separated by not less than 40 feet of natural strata, and all crosscuts between them shall be closed with stoppings of fireproof material. In shaft mines, such openings provided after August 12, 1949, must be separated by not less than 200 feet of natural strata. The second opening may be made through an adjoining mine. Until these provisions are met, not over five men in a drift, 10 men in a slope, and 20 men in a shaft shall work in the mine at one time, and no additional development shall be permitted until the connection is made to the second opening. In mines wherein final pillar robbing operations necessitate closing the second opening, the above limitations as to the number of men permitted to work will apply until the mine is worked out and abandoned. (b) Both openings...
alisondb.legislature.state.al.us/alison/CodeOfAlabama/1975/25-9-84.htm - 6K - Match Info - Similar pages
25-9-80
Section 25-9-80 Main fans. (a) All main fans shall be installed on the surface, in fireproof housings, the fan situated not less than 30 feet from its air shaft or air course and on one side of the line of such opening so that the fan will not be in direct line of the force of a blast or explosion. The air duct connecting the fan with the mine opening shall be fireproof and provided with self-closing explosion doors. (b) In mines ventilated with multiple fans, each main fan shall be equipped with fireproof doors automatically closing in the event of a fan failure to prevent air reversal through the fan. (c) Every main fan installed after August 12, 1949, ventilating a mine classed as gassy, must have an auxiliary drive mechanism that will operate the fan at not less than 80 percent of its regular volume. Dual fan installations, independently powered so that one is operative at 80 percent of regular volume during electrical failures, meet this requirement. (d) All main fans are required...
alisondb.legislature.state.al.us/alison/CodeOfAlabama/1975/25-9-80.htm - 3K - Match Info - Similar pages
25-9-300
Section 25-9-300 Map of mine - Required; contents; filing; examination, etc. The owner, operator, or lessee of any underground coal mine in this state shall make or cause to be made by a competent engineer an accurate and exact detail map of said mine, showing the exact position of said mine in reference to the section line, which shall be connected with known boundary lines of the section or subdivision of the section. Such map shall show accurately the position of any branches, creeks, rivers, railroads, oil and gas pipelines under which said mine workings extend and, as near as possible, the position of any coal mines nearby. The location of all oil and gas wells shall be shown on said map. Said maps shall show all shafts, slopes, tunnels, or other openings to the surface or to the workings of a contiguous coal mine; all excavations, entries, rooms, and crosscuts; the location of the fan and the direction of the air currents; the location of pumps, hauling engines, engine planes,...
alisondb.legislature.state.al.us/alison/CodeOfAlabama/1975/25-9-300.htm - 3K - Match Info - Similar pages
25-9-86
Section 25-9-86 Examinations for gases and other dangerous conditions. (a) Operators of mines are required to employ one or more certified fire bosses and to have a preshift examination made. The duties of the fire boss are to examine for dangerous conditions all manways, slopes, and entries used by men in traveling to and from work and to examine for gas and other dangerous conditions all working places, adjoining abandoned places, and accessible pillar falls for accumulation of gas. The fire boss will ascertain that the air is traveling in its proper course and that all ventilation appliances are in good condition and working effectively. The fire boss will indicate his examination of working and abandoned places, pillar falls, and ventilating appliances by marking his initial and the date conspicuously in or on such places. (b) Whenever gas is detected or danger exists to men entering any place, the fire boss shall leave at each entrance to the place a conspicuous DANGER sign. (c)...
alisondb.legislature.state.al.us/alison/CodeOfAlabama/1975/25-9-86.htm - 4K - Match Info - Similar pages
40-12-46
Section 40-12-46 Air-conditioning plants and equipment. Each person engaged in the business of selling or installing air-conditioning plants or equipment which use or require the use of water connections shall pay, in the county in which is located his principal office, an annual state privilege tax of $100 and a county privilege tax of $50; provided, that in each other county in which such person engages in the business of selling or installing such air-conditioning plants or equipment, he shall pay a state license tax of $10 and a county license tax of $5; provided further, that no person subject to the provisions of this section shall be required to pay the license tax levied hereunder in any county other than where he maintains a regular and established place of business for the purpose of selling or installing such air-conditioning plants or equipment. Any person other than those persons licensed under paragraph one hereof engaged in the business of selling or installing...
alisondb.legislature.state.al.us/alison/CodeOfAlabama/1975/40-12-46.htm - 2K - Match Info - Similar pages
25-9-134
Section 25-9-134 Blasting practices and procedures generally. (a) Only competent persons shall be designated or permitted to handle explosives or do blasting. Only electric detonators of proper strength may be used and the use of delay electric detonators is prohibited for blasting coal or coal and other material. Primers shall be made up as needed for blasting and prepared in accordance with the safety standards of the Institute of Makers of Explosives or of the manufacturer of the explosives as approved by the chief; provided, however, that nothing provided in this subsection shall prohibit the use of permissible millisecond blasting in conformity with the requirements, exceptions, limitations, conditions, and restrictions on the use thereof established or hereinafter established by the Bureau of Mines of the United States Department of the Interior. (b) Care shall be used in placement and drilling of holes. Test roof, face, ribs and timbers for dangerous conditions before drilling...
alisondb.legislature.state.al.us/alison/CodeOfAlabama/1975/25-9-134.htm - 6K - Match Info - Similar pages
15-23-3
Section 15-23-3 Definitions. As used in this article the following words shall include, but are not limited to the following meanings unless the context clearly requires a different meaning: (1) COMMISSION. The Alabama Crime Victims Compensation Commission as created by Section 15-23-4. (2) CRIMINALLY INJURIOUS CONDUCT. Criminally injurious conduct includes any of the following acts: a. An act occurring or attempted within the geographical boundaries of this state which results in serious personal injury or death to a victim for which punishment by fine, imprisonment, or death may be imposed. b. An act occurring or attempted outside the geographical boundaries of this state in another state of the United States of America which is punishable by fine, imprisonment, or death and which results in personal injury or death to a citizen of this state, and shall include an act of terrorism, as defined in Section 2331 of Title 18, United States Code, committed outside of the United States,...
alisondb.legislature.state.al.us/alison/CodeOfAlabama/1975/15-23-3.htm - 8K - Match Info - Similar pages
13A-8-36
Section 13A-8-36 Damage or destruction of property. (a) It is unlawful for a person with the intent to damage property and having no right to do so or any reasonable ground to believe that he or she has such a right, damages or destroys any of the following: (1) Telecommunications, cable communications, or electric power transmission pedestal or pole owned or operated by a telecommunications, cable, or electric power company or cooperative, or electric power supplier, or railroad. (2) Telecommunications, cable communications, or electric power grounding or any other equipment or materials used in the delivery of electricity, wire, fiber insulator, power supply transformer, ground wire, or other apparatus, equipment, or fixture used in the transmission of telecommunications, cable communications, or electric power owned or operated by a telecommunications, cable, or electric power company or cooperative, or electric power supplier, or railroad. (3) Equipment used in the transmission of...
alisondb.legislature.state.al.us/alison/CodeOfAlabama/1975/13A-8-36.htm - 5K - Match Info - Similar pages
8-20-4
Section 8-20-4 Unfair and deceptive trade practices. Notwithstanding the terms, provisions, or conditions of any dealer agreement or franchise or the terms or provisions of any waiver, prior to the termination, cancellation, or nonrenewal of any dealer agreement or franchise, the following acts or conduct shall constitute unfair and deceptive trade practices: (1) For any manufacturer, factory branch, factory representative, distributor, or wholesaler, distributor branch, or distributor representative to coerce or attempt to coerce any motor vehicle dealer to do any of the following: a. To accept, buy, or order any motor vehicle or vehicles, appliances, equipment, parts, or accessories therefor, or any other commodity or commodities or service or services which such motor vehicle dealer has not voluntarily ordered or requested except items required by applicable local, state, or federal law; or to require a motor vehicle dealer to accept, buy, order, or purchase such items in order to...
alisondb.legislature.state.al.us/alison/CodeOfAlabama/1975/8-20-4.htm - 34K - Match Info - Similar pages
25-9-230
Section 25-9-230 Face equipment. (a) The cutter chains of mining machines shall be locked securely at all times except when the machine is cutting, the chain is being oiled or tested after repairs, or when the chain is moved to spot bits. (1) When the chain is being oiled or tested after repairs, an operator must be at the controls ready to stop movement of the chain instantly. When the chain is being oiled, the bar must be free of the kerf and of material that might cause it to deflect, the person oiling must position himself before the chain is started, the chain must run in reverse and slowly and must be stopped and the lock replaced immediately after oiling is completed. Oiling devices or other methods that do not expose a workman to hazard from the moving chain may be used. (2) When the chain is moved to spot bits, all persons must be in the clear of the bar and the lock must be replaced after the chain is moved and before the bits are spotted. (3) When the chain is operated to...
alisondb.legislature.state.al.us/alison/CodeOfAlabama/1975/25-9-230.htm - 6K - Match Info - Similar pages
|