25-9-136
Section 25-9-136 Misfires. (a) Where misfires occur with electric detonators, the person firing the shots shall disconnect his firing cable from the source of power and short circuit it by reshunting the ends of the cable. No person shall return to the shot until five minutes has elapsed from the misfire, and the firing cable must not be left behind anyone returning to the face. (b) If a defect in the firing cable or connections is found, another attempt may be made to fire the shot or shots, exercising such cautions as covered in Section 25-9-134, subsection (f), subdivision (5). (c) If the misfire is definite, explosives shall be removed by drilling and firing the bore hole for a separate charge at least two feet away from and parallel to the misfired charge, or by washing the stemming and the charge from the bore hole with water or by inserting and firing a new primer after the stemming has been washed out. (d) A very careful search of the working place, and if necessary, of the...
alisondb.legislature.state.al.us/alison/CodeOfAlabama/1975/25-9-136.htm - 1K - Match Info - Similar pages
25-9-278
Section 25-9-278 Blasting practices and procedures generally. (a) All blasting shall be done in a safe manner after all persons have been removed to a safe place. (b) All blasting should be done electrically or with detonating fuse. (c) Primers shall be made up near the working place by competent persons experienced in handling explosives. Competent persons shall also load, assist in loading, or supervise the loading or charging of drill holes. (d) Primers shall be prepared in accordance with safety standards of the Institute of Makers of Explosives or of the manufacturer of the explosives as approved by the chief. Holes made in the primer cartridge for the purpose of inserting the detonator shall be made with a wooden or other nonsparking implement. (e) In tamping holes, only a wooden tamping bar or other nonsparking tamping bar shall be used. Before charging drill holes, except well holes, they shall be thoroughly cleaned. Explosives shall not be violently tamped in the drill hole...
alisondb.legislature.state.al.us/alison/CodeOfAlabama/1975/25-9-278.htm - 5K - Match Info - Similar pages
25-9-134
Section 25-9-134 Blasting practices and procedures generally. (a) Only competent persons shall be designated or permitted to handle explosives or do blasting. Only electric detonators of proper strength may be used and the use of delay electric detonators is prohibited for blasting coal or coal and other material. Primers shall be made up as needed for blasting and prepared in accordance with the safety standards of the Institute of Makers of Explosives or of the manufacturer of the explosives as approved by the chief; provided, however, that nothing provided in this subsection shall prohibit the use of permissible millisecond blasting in conformity with the requirements, exceptions, limitations, conditions, and restrictions on the use thereof established or hereinafter established by the Bureau of Mines of the United States Department of the Interior. (b) Care shall be used in placement and drilling of holes. Test roof, face, ribs and timbers for dangerous conditions before drilling...
alisondb.legislature.state.al.us/alison/CodeOfAlabama/1975/25-9-134.htm - 6K - Match Info - Similar pages
25-9-279
Section 25-9-279 Electrical blasting practices and procedures. (a) When loading or charging blast holes with electric detonators, all electric power within an unsafe distance of the place to be blasted shall be deenergized. (b) Electric blasting with blasting machines or special circuit is permissible. With blasting machines, connections shall be made in series or in a combination connection recommended by the manufacturer. With power currents, connections shall be made in series, parallel, or a combination of the two. (c) When blasting is by means of a special blasting circuit, no one shall enter the place in which the blasting has been done until the permanent blasting wires have been disconnected from the source of electrical energy and the blasting switch has been locked in the open position. (d) The person responsible for blasting shall be in charge of the blasting machine when it is in the pit. No other person shall connect the blasting machine to the leading wires, and such...
alisondb.legislature.state.al.us/alison/CodeOfAlabama/1975/25-9-279.htm - 5K - Match Info - Similar pages
25-9-274
Section 25-9-274 Electrical equipment installations and inspections; grounding and insulation of electrical equipment; trailing cables. (a) Installations and inspections. All electrical equipment installations shall be approved and all electrical inspections made by a qualified person. (b) Grounding. (1) Where grounding wires are used to ground metallic sheaths, armors, conduits, frames, casings, and other metallic enclosures, such grounding wires will be approved if: a. The cross-sectional area (size) of the grounding wire is at least one-half the cross-sectional area (size) of the power conductor where the power conductor used is No. 6 A.W.G. or larger. b. Where the power conductor used is less than No. 6 A.W.G., the cross-sectional area (size) of the grounding wire is equal to the cross-sectional area (size) of the power conductor. (2) The protective grounding of electrical circuits and equipment to water pipe systems, when available, is desired as such grounding offers the most...
alisondb.legislature.state.al.us/alison/CodeOfAlabama/1975/25-9-274.htm - 4K - Match Info - Similar pages
31-1-1
Section 31-1-1 Record of releases from active duty from military service (a) The county commission of each county shall cause to be prepared and furnished to each judge of probate a well-bound book of record, the back or side of which shall bear the following words, "Record of Releases from Active Duty from the United States Army, Air Force, Coast Guard, Navy, or Marine Corps." The pages of the book of record shall correspond with the printed matter appearing on a release from active duty from the military service of the United States of America, with sufficient blank spaces reserved thereon for the copying therein of the data and information appearing on a release from active duty, which may be presented to the judge of probate for record, as provided in this section. (b) Any person who holds a release from active duty, or DD Form 214, from the United States Army, Air Force, Coast Guard, Navy, or Marine Corps may present the DD Form 214 to the judge of probate of the county wherein he...
alisondb.legislature.state.al.us/alison/CodeOfAlabama/1975/31-1-1.htm - 3K - Match Info - Similar pages
34-27-32
Section 34-27-32 Requirements for license; application; place of business; branch offices; multiple brokers; fees. (a) A license for a broker or a salesperson shall be registered to a specific real estate office and shall be issued only to, and held only by, a person who meets all of the following requirements: (1) Is trustworthy and competent to transact the business of a broker or salesperson in a manner that safeguards the interest of the public. (2) Is a person whose application for real estate licensure has not been rejected in any state on any grounds other than failure to pass a written examination within the two years prior to the application for real estate licensure with Alabama. If the applicant's rejection for real estate licensure in any state is more than two years from the date of application for licensure with Alabama, then the applicant may not be issued an Alabama real estate license without the approval of the commissioners. (3) Is a person whose real estate license...
alisondb.legislature.state.al.us/alison/CodeOfAlabama/1975/34-27-32.htm - 11K - Match Info - Similar pages
11-49-1
Section 11-49-1 Consent to use public streets, etc., for construction or operation of public utility or private enterprise; fees. (a) No person, firm, association, or corporation shall be authorized to use the streets, avenues, alleys, and other public places of cities or towns for the construction or operation of any public utility or private enterprise without first obtaining the consent of the proper authorities of the city or town. (b) No electric supplier, as defined in Section 37-14-31(1), which has an assigned service territory established by general law enacted by the Legislature and which is subject to payment of a privilege or license tax or other tax or fee established by general law enacted by the Legislature to a city or town which authorizes a levy not to exceed three percent of the gross receipts of the business done by the electric supplier in the municipality during the preceding year, and which authorizes a levy not to exceed one and one-half percent of the gross...
alisondb.legislature.state.al.us/alison/CodeOfAlabama/1975/11-49-1.htm - 4K - Match Info - Similar pages
|